cavity angle
英 [ˈkævəti ˈæŋɡl]
美 [ˈkævəti ˈæŋɡl]
网络 洞角
双语例句
- The extra-uterine pregnancy refers to the fertilized egg outside uterine cavity spot, like oviduct, palace angle, abdominal cavity, ovary and so on place bed growth.
宫外孕是指受精卵在子宫腔以外的部位，如输卵管、宫角、腹腔、卵巢等处着床发育。 - As soon as rotate piston compressor be concerned, considing the thickness of slider and inference the change rule that the basic capacity of intake cavity with rotate angle.
对于滚动活塞压缩机，将滑片厚度考虑在内，推导出吸气腔基元容积随转角的变化规律。 - The left thoracic duct begins in the abdominal cavity as a single trunk and ascends along the left side of the aorta. It empties into the left jugular venous angle. This type of the duct occurred in 0.67 per cent.
左位型胸导管，在腹控以单干起始，上行于主动脉左侧，注入左颈静脉角，出现率为0.67%。 - The influence of overflow, rotate-flow cavity, cone angle, tail-pipe on Oil-Water separation efficiency was introduced.
介绍了双锥结构的旋流器的溢流口、旋流腔段、大锥体段角度、小锥体段角度和尾管等组成部分有关设计参数对油水分离效率的影响。 - Comparing to original cavity, the output energy increase about 40 percent, the width of output pulse decrease about 10 ns, the divergence angle decrease 0.1 mrad under the same conditions.
同等条件下，改进型对撞腔输出能量约提高了约40%，脉冲压窄了约10ns，发散角减小0.1mrad。 - A compact anti-maladjusted OPO laser has been developed using a directional prism cavity and a Cr ∶ YAG crystal oriented its Brewster angle as a passive Q-switch.
泵浦源激光器，采用布氏角切割的Cr∶YAG晶体作为被动Q开关，定向棱镜作为谐振腔全反镜，使得整个OPO激光器具有结构紧凑、抗失调能力强的特点。 - Conclusion: Fiber thoracoscopy is an important method of diagnosing the difficult and complicate pleura cavity diseases and has advantages of high positive diagnose rate, small hurt, big angle of view, simple operation, low complication and recovering fast after operation etc.
结论纤维胸腔镜检是诊断疑难性胸膜腔疾病的一项重要措施，具有阳性率高、创伤小、视角大、操作简单、并发症少及术后恢复快等优点。 - The critical safety thickness of hidden cavity is not sensitive to influence angle of stratum.
暗穴临界安全厚度对地层影响角的变化不敏感。 - According to the frequency and the quality factor of the cylindrical cavity unloaded and loaded, the system can calculate the permittivity ε′_r and the loss angle tangent tan δ of the materials being tested.
该系统可根据加载介质前后圆柱谐振腔的谐振频率和品质因数，计算出被测材料的相对介电常数εr′和损耗角正切tanδ。 - In order to reduce defects, such as the dead zone, the shrinkage cavity and the surface cracks, caused by non-homogeneous metal flow in extrusion process, an extrusion process is proposed by using a die with the guiding angle.
为了减少平模挤压时因金属流动不均匀而产生死区、缩孔及表面裂纹等缺陷，在此采用了一种带导流角结构的芯模用于挤压。 - Conclusion To improve the repair quality of teeth filled with combined resin, cavity margin angles should be designed as short slant with an angle of 70 ° or so.
结论为改善复合树脂充填牙齿的修复质量，应该将洞缘角设计成70°左右的短斜面。 - Accordingly, along with the improvement of gas medium homogeneity and mode selectivity of the optical cavity, chemical laser has also attained high beam quality of a near diffraction-limited divergence angle.
近年来，由于流动介质均匀性的改善和采用选模能力高的光腔，光束质量亦已达到近衍射极限。 - This paper presents the analysis of the effects of the tilt angle of the F-P cavity mirror on the interference fringes and the optical loss caused by the cross malposition and the tilt angle of the cavity mirror.
分析光纤双法-珀干涉仪腔镜的倾斜角对干涉条纹的影响，腔镜横向错位以及倾角引起的光强损耗等。 - Inflammatory pseudotumor: bilateral margin of node was upright to thoracic cavity, knife cut sign, crenate sign, long hair spine sign, tip angle, satellite node, apparently pleura reaction and apparent absorption shrinkage after anti-inflammation therapy.
炎性假瘤：病灶双侧缘垂直于胸腔、刀削征、锯齿征、长毛刺、尖角、卫星灶、胸膜反应明显，抗炎明显吸收缩小。 - It showed that the material property ( Modulus of elasticity), operating conditions ( input torque, maximum traction coefficient and etc.) and geometrical parameters ( aspect cavity ratio, curvature ratio and half cone angle of power roller) play important roles in such a system.
得出了材料性能（弹性系数）、工况条件（输入扭矩和最大牵引系数）和几何参数（曲面盘几何比，曲率比和动力滚轮的半锥角）对该传动的性能有重要影响的结论。 - We study how parameters such as input power and prism beam expanding rate impact to the relaxation oscillation, optimizing twisted-mode cavity and extending beam with double prism system which is composed of right angle prism.
研究了泵浦功率、棱镜扩束率等参数对激光弛豫振荡输出功率的影响；对扭摆腔进行优化，选择直角棱镜组成双棱镜系统进行光扩束，组合光栅对激光线宽压缩进行选频。 - The response is obtained by designing P area in absorption cavity as gradual-thickness structure with 0.86 ° inclination angle.
通过将探测器吸收腔的P区设计为具有0.86°倾角的厚度渐变结构，实现了平顶陡边响应。 - This article discussed the time of iso-static pressing oil cavity compression and presses maintaining stage changed along with the powder formation of pressure from value simulation angle.
论文利用数值仿真的方法研究等静压油腔加压和保压阶段所需时间随粉料成型压强之间的变化关系。 - For the isosceles trapezoidal cavity and the right-angled trapezoidal cavity, the effects of Reynolds number and the top angle θ on the strength, center position and number of vortex are studied.
本文讨论了等腰梯形空腔和直角梯形空腔中，雷诺数的变化及梯形顶角θ的改变对空腔内的流动现象，即出现的涡的强度、位置及个数的影响。 - The influences of cavity shape, property of media, wave numbers and angle of incidence upon the property of scattering wave at far-fields are discussed. 4.
讨论了孔的形状、介质的性质、入射角和波数对散射远场特性的影响。 - Increasing the length-to-depth ratio of the cavity or the cavity aft ramp angle causes the flame to move upstream and to increase its intensity.
增大凹腔长深比或凹腔后壁倾角也可使火焰区前移、火焰强度增大。 - The results suggest that: for the cavity flame holder, the combustion efficiency and total pressure loss exhibit different trend when the length and slope angle of the rare wall is changed.
研究表明：对凹腔火焰稳定器：凹腔长度和后壁倾角A的变化对燃烧效率和总压损失的影响呈现出相反的变化趋势。